Installation and start up of XW series pumps 11196/11197/11202 and motor pump units

Figure 1   Typical vertical installation.

XW motor/pump units may be installed either horizontally or vertically. It is recommended that vertical units are mounted through a slot cut into a support plate or platform, typically as shown in Figure 1 and Figure 2. This allows the unit to be removed with minimum overhead clearance. Marshalsea bell housings carry an additional 4 tapped holes on the same PCD as the motor fixing bolts to allow the complete motor/pump assembly to be secured to a suitable mounting platform. Refer to Marshalsea Hydraulics for details of the bolt sizes for each type of bell housing. Horizontally mounted units are secured using the motor mounting feet as shown in Figure 3 Figure 2   Recommended mounting method for vertical installation.

Figure 3   Typical horizontal installation.  :